Marine "Prop-Shaft" Dynamometer - Load Chart

The following graphs will help you determine if the absorber's load capacity vs. RPM curve is a suitable match for the engine to be tested.

"For better control, the engine being tested should not be at the extreme high or low range of the absorber's capacity."

Important: These maximum curves assume a full absorber. If you are running an inadequate water supply system, then you will not be able to reach these maximums.

WARNING: These are only the hydraulic torque (in foot-pounds) and Hp limits for each absorber. They do not take into account any other mechanical limits imposed by the dynamometer's hardware.

For DYNO-mite dynamometer technical assistance - telephone or e-mail: sales@land-and-sea.com
© 17 May 2008 Land & Sea, Inc. 25 Henniker Street; Concord, NH 03301-8528 USA  +1-603-226-DYNO