|
PWC Dynamometer - Load Chart |
|
(603) 329-5645 |
The
following graphs will help you determine if the absorber's load capacity vs. RPM
curve is a suitable match for the engine to be tested.
"For better control, the engine being tested should not be at the extreme high or low range of the absorber's capacity."
Important: These maximum curves assume a full absorber. If you are running an inadequate water supply system, then you will not be able to reach these maximums.
WARNING: These are only the hydraulic torque (in foot-pounds) and Hp limits for each absorber. They do not take into account any other mechanical limits imposed by the dynamometer's hardware.
